The edge banding machine can accurately perform straight-line edge banding, trimming and polishing operations on furniture panels, but many people ignore the maintenance work of the edge banding machine when using the fully automatic edge banding machine. Although maintenance may consume a certain amount of manpower and material resources, it can prolong the service life of the machine and improve work efficiency. Therefore, the maintenance of the machine is very important. If the furniture edge banding machine is frequently used daily and the maintenance is not in place, it will lead to the premature aging of the edge banding machine equipment over time, thereby shortening the service life, so the daily care and regular maintenance of the edge banding machine are essential. The side machine mainly has the following basic operations:

1. Regular lubrication: Lubricate the bearings of each part of the edge banding machine with lubricating oil, and be sure to choose the appropriate lubricant, otherwise it will also affect the normal use of the edge banding machine.
2. Regular inspection: Regularly inspect and maintain the automatic edge banding machine. During the maintenance process, you must carefully check some wear conditions of gears, bearings and other parts, and replace the severely worn parts in time. Once found, tighten it immediately, if necessary. Replace the screws.
3. Clean up in time: clean up the sawdust and various sundries produced during the production process to prevent the above waste accumulation from causing machine jams and affecting the normal use of the machine. Secondly, clean up some stains on the surface of the machine in time to keep the edge banding machine clean and tidy. , It also prevents harmful substances from causing corrosion and damage to the surface of the fuselage.
4. Timely removal: Remove the waste around the edge banding machine and keep the operating area clean.
5. The amount of glue applied and the temperature of use should be adjusted according to the thickness, width and size of the workpiece, as well as the heating capacity of the edge banding machine itself.
6. Clean the rubber pot regularly: prevent long-term high temperature heating from forming carbon deposits, which will affect the normal heating effect of the equipment.
7. The glue return port should be kept unobstructed: otherwise the lower port of the workpiece will be very dirty, which will affect the quality. At the same time, the glue will also be attached to the conveyor belt and the travel switch, causing the travel switch to malfunction and damage the workpiece and equipment.
Although the edge banding is small, it cannot be ignored. Today's little knowledge is explained here, and we will see you in the next issue.